First virtual burn, failed
Posted: Wed Jul 25, 2012 9:59 pm
I'd like to burn a win7/64 recovery disk iso - to put on a usb drive.
I just installed TotalMounter specifically to do this, but it fails.
It says "Unspecified error (0x80004005) " ... same as this fellow here: viewtopic.php?f=6&t=2213
This is a fairly fresh install, less than a month old, so it's a pretty clean machine.
I've rebooted, shut down antivirus. My windows user is administrator, and UAC has always been turned off.
I've attached anything else I see, which isn't much.
Anything I can help to debug this for you? Any ideas?
I just installed TotalMounter specifically to do this, but it fails.
It says "Unspecified error (0x80004005) " ... same as this fellow here: viewtopic.php?f=6&t=2213
This is a fairly fresh install, less than a month old, so it's a pretty clean machine.
I've rebooted, shut down antivirus. My windows user is administrator, and UAC has always been turned off.
I've attached anything else I see, which isn't much.
Anything I can help to debug this for you? Any ideas?