KernSafe Technology

Hello,
are considering the following scenario.

One iStorage server with two or more network cards, each connection into another switch and a server with similar configuration.

EX
iStorage Server iSCSI Target
------------------------
NIC 1: 192.168.1.11/24 <-> SW1
NIC 2: 192.168.2.11/24 <-> SW2

server iSCSI Initiator
------------------------
NIC 1: 192:168:1.12 / 24 <-> SW1
NIC 2: 192.168.2.12/24 <-> SW2

I need to set up MPIO, so as to increase the throughput and reliability combined.
Unfortunately I never found a document on this scenario. In all bandaged up with only one network card on one server iStorage.
Thank you for any insights.

KaBub,

In order do it, you can configure multiple connected session (MCS).
First while discovering a target portal, press on the Advanced button and set up a Initiator and Target Portal IP. (Figure 1)
Then after connecting to a specific iSCSI Target, click on it and choose Properties (Targets tab). On the bottom you will see a MSC... button, click on it and add another connection. (Figure 2)
In the target properties, under Session Information, you will notice current number of connections. (Figure 3)
I hope that answered your question.

If you will have any additional questions, please don't hesitate to ask.